Manual No. 25-ULGPMU01-01 Series OPT Handheld
CCD Scanner
Page 64
Buzzer Settings
ZZ
Start/End
Program
Menu
-[[-
VZ
Buzzer
after
transmission
-W[-
GD
Disable
startup buzzer
-HE-
GC
Enable startup
buzzer
-HD-
Buzzer Settings - These options determine the buzzer type, tone, duration and loudness. By default, the buzzer is
disabled for Linker type readers.
Buzzer Type - The buzzer may be disabled or enabled as either a hardware of software buzzer. Not all readers
support both a hardware and software buzzer.
Buzzer Tone - If a software buzzer is used, the buzzer tone may be selected.
Buzzer Duration and Volume - If a software buzzer is used, a buzzer duration of 50, 100, 200 or 400 msec. may be
selected. Volume may also be adjusted.
Buzzer Before Transmission - The good read buzzer will be activated after decoding the bar code, but before
transmission. During transmission, the buzzer sequence will be completed.
Buzzer After Transmission - The good read buzzer will be activated after transmission.
Enable Startup Buzzer - When this option is selected, the reader will generate a single good read buzzer to
indicate the reader is ready after the reader is supplied with power.
Disable Startup Buzzer - When this option is selected, the reader will not sound the buzzer after the reader is
supplied with power.
To Next Page
Loading...
