5
2. Use a wire stripper to strip
1
/
4
inch
of insulation from each wire’s end.
Twist the loose wire strands to pre-
vent the wires from shorting.
3. Press the right front speaker’s
negative (–) terminal tab and
insert one of the bare wire ends
into the opening. Then release the
tab.
4. Press the right front speaker’s
positive (+) terminal tab and insert
the other bare wire end into the
opening. Then release the tab.
5. Insert the other end of the wire you
inserted into the right front
speaker’s negative (–) terminal
into your A/V amplifier/receiver’s
right front negative (–) speaker ter-
minal.
Amplifier/Speaker Connections with the Subwoofer Connected to
Speaker Terminals
40-4071.fm Page 5 Wednesday, August 11, 1999 10:16 AM
To Next Page
Loading...