29 of 49
OP940-SW
IL Settings
• IL Pass Threshold
• IL Precision
• IL Dwell Time
RL Settings
• RL Pass Threshold
• DUT Length
• Scan Offset
• RL Dwell Time
Miscellaneous Settings
• Temperature Units
• Startup Mode
Additionally, the Status Mode displays the revision numbers for key firmware on the unit.
OP940 System Information
Firmware Version
Main Firmware = 481
UI Firmware = 101
Display Firmware = 102
IL Settings
ILA Pass Threshold = 0.21
ILB Pass Threshold = 0.22
IL Precision = 3
IL Dwell Time = 771
RL Settings
RLA Pass Threshold = -55.0
RLB Pass Threshold = -55.0
DUT Length = 1 - 100 m
Scan Offset = 0.0
RL Dwell Time = 771
Misc Settings
Temperature Units = Celsius
Startup Mode = ILRL
Status Mode
Front Panel Operation
Status Mode
The Status Mode is a troubleshooting tool which displays the state of the various user-
configurable settings on the OP940. It can also be used to quickly check the unit’s settings
before beginning to test. The settings, which are displayed on this screen, are as follows:
To Next Page
Loading...