1
2
3
4
5
First of all clean hands before taking mask out of its packaging.
1. Prestretch top and bottom straps before placing respirator on the face.
2. Cup the respirator in your hand, with the nosepiece at your fingertips,
allowing the headbands to hang freely below your hand.
Do not touch the respirator on the inside.
3. Position the respirator under your chin with the nosepiece up. Pull the
strap over your head resting it high at the top back of your head.
Pull the bottom strap over your head and position it around the neck
below the ears.
! Pinching the nosepiece using one hand may result in improper fit and less
effective respirator performance. Use two hands.
4. Place your fingertips from both hands at the top of the metal nosepiece.
Using two hands, mold the nose area to the shape of your nose by pushing
inward while moving your fingertips down both sides of the nosepiece.
5. Perform a User Seal Check prior to each wearing. To check the respirator-
to-face seal, place both hands completely over the respirator and exhale
sharply. Be careful not to disturb the position of the respirator. If air leaks
around nose, readjust the nosepiece as described in step 4.
If you CANNOT achieve a proper seal, DO NOT enter the contaminated
area. Report to your supervisor.
Fitting - and Removal Instructions
Removal Instructions:
Hold the respirator in one hand to maintain the position on face. Pull bottom strap over head.
Still holding the respirator in position, pull to strap over head and remove respirator. Clean your
hands after removing the respirator. Dispose of used product in accordance with applicable
regulations. Single use only! Do not reuse!
Storage Conditions and Shelf Life (Details see last page)
Before use, store respirators in the original packaging away
from contaminated areas, dust, sunlight, extreme temperatures,
excessive moisture and damaging chemicals.
When stored in accordance with temperature and humidity
conditions specified below, the product may be used until the
"use by" date specified on packaging (5 years after production
date). Always inspect product and conduct a user seal check
befor use as specified in the User Instructions. If you cannot
achieve a proper seal or the mask holds no longer close
tightly, do not use the respirator.
Time Use Limitation
If respirator becomes damaged, soiled or breathing becomes
difficult (e.g. saturated with breathing air humidity), leave the
contaminated area immediately and replace the respirator.
The respirator is intended for single use and cannot be
reused.
Acceptable Fit Test Protocols
Fit Test Protocol*
Quantitive Protocols Saccharin Acceptable with this product!
Bitrex TM Acceptable with this product!
Quantitative Protocols* Acceptable with this product!
*Refer to OSHA 1910.134.
To Next Page
Loading...
