oraimo OSS-L101A - Specifications; Product Operation Instructions; Charging Instructions

Specifications
Size: 1100*113*71mm
Rated Voltage: DC 3.7V
Battery Capacity: 2500mAh
Material: ABS
Product Operation Instructions
WARNING
* Always wear rubber gloves and keep proper eye protection to avoid
contact from splashing of soaps or detergents on skin and/or eyes while
brush head is spinning and when brushes are removed or attached.
* After using oraimo UltraCleaner Scrubber, turn the unit off while brush is
still in contact with surface to avoid getting splashed with soaps or
detergents.
Always test on a small, inconspicuous area before using on a larger area.
* Always follow surface manufacturer's guidelines for cleaning and mainte-
* nance.
Do not expose the unit to excessive water. If oraimo UltraCleaner Scrubber
accidentally becomes submerged in water or water gets into *Charging
Port", shake out liquid and air dry the machine 24 hours at least.
-Choose proper Brush Attachment and attach to oraimo UltraCleaner
Scrubber as directed in "Assembly Instructions.
* Dome Brush: Best for large jobs, cleaning tile, and grout.
* Corner Brush: Best for corners, door tracks, and tight spaces.
« Large Flat Brush: Best for tough jobs, where you need to focus power on
a certain area.
2-Wet the intended area and apply desired cleaning product.
3-Place tip of brush on surface to be cleaned.
4-Press ON/OFF button to switch on the machine, then adjust the speed by
press speed button.
5-When done, press ON/OFF button to turn off.
Charging Instructions
*In order to extend the battery life, please avoid consecutive charging exceed 12
hours. It is not necessary to wait until battery power is fully depleted before
recharging.
1. Make sure tum off the machine before charging.
2.0pen "Charging Port Cover" located on bottom of "Handle" of machine.
3.Insert cable end of * Charger” into "Charging Port."
4.Plug "Charger" into wall outlet. The indicator light next to "Charging Port" will
tum to RED to show the machine is charging.
5.The Red light turns to Blue after the machine is fully charged. Blue light will
remain lit when the battery is completely charged.
6.When done, close *Charging Port Cover".
2
Charging
Working
Low Battery
Fully charged
Motor blocking
Failure to connect parts properly
Cleaning & Maintenance
1.Use a wet, non-abrasive cloth to clean oraimo UltraCleaner Spin Scrubber. If
needed, use a mild detergent. Then place it in a dry environment to allow it
to dry thoroughly.
Note:
(D Do NOT immerse or run under water.
@ Do NOT clean with alcohol or petrol.
2.Rinse Brush attachments under water and clean thoroughly after use. Then
place them in a dry environment to air dry them thoroughly.
Correct Disposal of this product:
This product uses a Li-ion rechargeable and recyclable battery. When it can
no longer be recharged, it should be removed from the unit and recycled.
The battery must not be incinerated or composted.
Attention
When using the electric spin scrubber, basic precautions should always be
followed, including the following:
* Before the first operation, read this manual carefully and keep it for future
reference.
*This product is not a toy. Close supervision is required when this machine is
used by or near children.
Store out of reach of children.
To protect against the risk of electric shock, do not put the battery charger
in the water or other liquid. Do not charge battery if it is wet or shows signs
of corrosion, Do not place o store appliance where it can fall or be pulled
into a tub or sink.
* Do not incinerate the battery. It may explode in a fire. A small leakage from
the battery cell may occur under extreme usage, charging or temperature
conditions. This does not indicate a failure. However, if the outer seal is
broken, cracked or damaged and this leakage gets on your skin: Please
wash it immediately with soap and water or neutralize with mild acid such
as lemon juice or vinegar. If the liquid gets into the eyes, flush them
immediately with dean water for at least of ten minutes. Seek medical
attention.