5
EN
Unpack/Packaging
• Unpack the equipment and remove any parts of the packaging materials
and labels from the machine before putting it into operation. Store packaging
materials in a safe place, especially out of the reach of children and
incapacitated persons, or dispose of them safely.
Inspection/Commissioning
• We recommend that you perform both initial and follow-up periodic inspections
of the equipment.
• Never use the appliance if it is incomplete, damaged, or any part of it is
damaged during use.
• Do not use non-original and incomplete equipment and accessories. There is a
risk of serious injury!
• If the equipment has been transported and stored at low temperatures
or excessive humidity (eg winter), leave it for about „Acclimatize“ at room
temperature for 1 hour to remove any moisture in the electronic components
that occurs when the ambient temperature changes.
There is a risk of damage to the equipment!
Location/Installation
• Only place the device on:
- flat, strong and stable mats - for floors and stable mats with a solid surface
finish and with sufficient load-bearing capacity.
• Always make sure that the space you want to place the equipment has
sufficient space, mechanical strength and load capacity.
• Do not use the appliance on a wet and slippery floor and mat. There is a risk of
serious injury!
There is a risk of damage to the equipment or other material damage!
Warning!
Do not place the device:
- uneven, unstable and dirty surface
- on the tight edge of stairs or other floor irregularities,
- near containers with water or other liquids.
Warning!
• Place the machine in a place where children cannot reach it freely.
• Keep children away from the machine. The device may fall over children and
cause injury.
• Mechanical damage (eg rupture of plastic or glass covers) may cause serious
injury.
There is a risk of serious injury!
There is a risk of damage to the equipment or other material damage!
To Next Page
Loading...
