EasyManua.ls Logo

Orava EV-600BT - Page 7

Orava EV-600BT
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
EN
the device when storing.
Never overload the equipment beyond the limits specified in
the technical data!
Do not overload the device above the measuring range.
Do not continue to use the device if you notice any non-
standard features while using the device. Have the device
checked by a specialist garage.
If any safety part/component (mechanical, electrical/
electronic) is part of the equipment, never disassemble this
part/component! if it is safety part/component damaged or
inoperative, do not use the device!
Never underestimate possible hazards and be careful!
Power Supplies/Batteries
Safety instructions for changing and loading the power supply - batteries
Warning!
When using electrical/electronic equipment that is equipped with a DC power
source - battery , always follow important safety and operating instructions and
handling of these sources.
Warning!
Never recharge batteries!
Never disassemble the batteries!
Never heat or dispose of batteries in a fire!
• Failure to follow the safety instructions may result in:
Risk of serious injury! Danger of explosion!
Chemical hazard!
Risk of equipment damage or other material damage!
Warning!
There is a danger of incorrect replacement and handling - electric short circuit,
explosion, electrolyte leakage, chemical burns.
Dispose of the batteries in accordance with the applicable regulations and
disposal of electronic equipment.
Warning!
Always store batteries out of the reach of children, disabled people and pets.
Keep the used batteries in a safe place so that they cannot be swallowed by
children and dispose of as soon as possible. Seek medical advice immediately
if swallowed.
Use only the same or equivalent type of batteries specified by the manufacturer.
Do not use new batteries with old ones. This may cause damage to the device.
Wipe the batteries with a dry cloth before loading them into the machine. This
ensures better electrical contact.
Insert the batteries so that the „+“ and „-“ symbols on the batteries and on the
inside of the machine cover match.

Related product manuals