12
speed and incline,but the system will adjust the speed and incline to make your pulse close to the
default pulse automaticlly.；
It has a warm-up status of one minute after beginning your exercise program, the system will not adjust
the speed and incline automatically, you can only adjust it manually; one minute later, system will
automaticlly add speed with 0.5km/h rate according to your pulse. If it’s still not close to target pulse
when you reach the default speed the system will start to incline 1 level at a time to make your heart
rate increase as close to the target rate.
Remark:Heart rate control program must use the chest strap transmitter, to test pulse, and the chest
strap transmitter must make good contact to your chest and skin.
2. Pulse display on console, either using chest belt or hand-held pulse pads, may have variance to your
actual heart rate at any given time, due to gender difference, chest belt position, wetness of skin,
contact in between HR sensor and user, battery capacity, distance and angle to built-in HR receiver and
other potential interference from surrounding environment. The HRC programs are designed based on
ACSM findings, however, users are advised to test run the programs and modify them where necessary
to suit your personal needs before commit to rountine
Range of data:
Parameter
PROGRAM
BEGIN SET UP RANGE
DISPLAY RANGE
TIME(MIN:SECOND)
0:00 15:00 10:00-99:00
0:00－99:59
INCLINE(%)
0 0 0-15 0-15
SPEED(K/h)
1.0 1.0 1.0-18 1.0-18
DISTANCE(K)
0 1.0 0.5-99.9
0.00－99.9
PULSE(hypo/min)
P N/A N/A 50-200
CALORIE(THERM)
0 50 10-999
0－999
Safety lock function
Pull out the safety rope, then the treadmill will stop immediately. All the windows display“―――”，the
buzzer will make 3 sound “B—B—”,now the treadmill must be stop. Attach the magnet end of the
safety rope to the computer, this will allow the treadmill to be powered up, ready to start.
Power save function:
The system has a power saving fuction, if you have started a program and stopped the system will go
into a power saving mode for 10 mins. During this time the display will close down . You can press any
button to wake up the display.
Turn off:
Turn off the power: You can close down the power to stop the treadmill, it won’t be damaged at any
time.
Caution:
1. We recommend that you maintain a slow speed at the beginning of a session and hold on to the
To Next Page
Loading...
