Orbit Watermaster 94026 User Manual (English)

Questions and Answers:

J
Joanne ButlerAug 8, 2025
Why is the LCD display not working on my Orbit Watermaster 94026 Timer?
- D
  Donald TurnerAug 9, 2025
  If your Orbit Timer's LCD is not displaying correctly, it might be due to a missing or low battery along with a lack of AC power. Try replacing the batteries and ensuring AC power is available. In some cases, the reset button may need to be pushed; if so, push it and re-enter your programs. Other possible causes include a power surge, faulty solenoid, short in the sprinkler wire (including the wire going to the pump), transformer not plugged in (for indoor models), permanent wiring issues (for outdoor models), or a main residential power outage. Check each of these to resolve the issue.
B
Beth LawsonAug 16, 2025
Why is my Orbit Watermaster 94026 Timer not watering properly?
- S
  Susan RuizAug 16, 2025
  If your Orbit Timer is causing watering problems, ensure that the rotary dial is set to "Auto." Also, make sure the main valve is turned on to supply water. Check the flow control stem on the valve to ensure it is not turned off. Verify that the Program Slide Switch is on the correct program (A, B, C) and that the sprinkler wire is properly connected to both the timer and the valve. Excessive water pressure can also cause issues, so consider installing a pressure reducer.
A
Adrian LangAug 25, 2025
What to do if LCD screen on Orbit Watermaster 94026 Timer is blank due to wiring issues?
- J
  Jessica SmithAug 25, 2025
  If your Orbit Timer is displaying a blank LCD screen, it may be due to a short in the sprinkler wire. Check the wire connections to resolve this. Also, if the sprinkler wire going to the pump is shorted, look for cuts in the wire or replace it.
N
Nicholas DeanAug 31, 2025
What to do if the Orbit Watermaster 94026 Timer LCD is not working because of a faulty solenoid?
- A
  Andrew CalhounAug 31, 2025
  If your Orbit Timer's LCD screen is not working, a faulty solenoid could be the cause. In this case, the suggested solution is to replace the faulty solenoid.