Oregon Scientific Action Cam ATC3K - Battery and Cold Weather Use; Safety and Disclaimer

Precaution:
Follow the steps below to keep the camera waterproof.
Step 1: Apply silicon grease (included).
Step 2: Ensure both o-rings are attached.
Step 3: Replace the cover.
Both o-rings need
silicon grease applied
to them. Follow the
instructions in Step 1.
Make sure the cover is
firmly closed.
3
4
Liquid may get inside the camera if the battery cover is not firmly
closed
• If the camera gets wet, wipe the liquid off as soon as possible with a dry cloth.
• Other camera accessories may not be waterproof.
• Ensure the o-rings are clean and have silicon grease applied before use underwater
or in wet conditions.
Using the camera in cold weather
• We recommend using Energizer e2 lithium batteries in cold weather.
Don't use the camera in extreme temperatures as this may cause the
camera to malfunction.
Attention:
• Non-rechargeable batteries are not to be recharged;
• Rechargeable batteries are to be removed from the camera before being charged;
• Rechargeable batteries are only to be charged under adult supervision;
• The supply terminals are not to be short-circuited;
• Exhausted batteries are to be removed from the camera.
Take out the o-rings and use your
fingers to gently rub on a thin layer
of silicon grease onto the surface of
the o-rings. The silicon grease needs
to be applied on the o-rings evenly.