10
GB
2. Press and hold the [ALARM/*] for 2 seconds to enter the
alarm time setting mode. The hour will be flashing.
3. Enter the hour using the [ ] or [ ] button.
4. Press the [ALARM/*] and the minute will be flashing.
5. Enter the minute using the [ ] or [ ] button.
6. Press the [ALARM/*] to confirm the alarm time and enter the
pre-alarm setting mode. “PRE-AL” icon will be shown.
PRE-ALARM FEATURE FOR REMOTE SENSOR
The alarm function also has a pre-alarm feature which can alert the
user before the preset alarm time when weather condition changes.
This Pre-alarm function applies with Remote sensor only.
(b) To set the Pre-alarm:
1. After setting the alarm time (as indicated above) the unit will
enter the Pre-alarm setting mode automatically. “PRE-AL” icon
will be shown and the time-interval will be flashing.
2. Use the [ ] or [ ] button to select the operating time
interval for this pre-alarm function. You can choose from “00”,
“15”, “30”, “45” and “60” minutes.
3. Press the [ALARM/*] to confirm and exit. The pre-alarm
function will be enabled automatically which is indicated by
the appearance of the [
*] symbol.
4. To disable this pre-alarm function, select the time interval as
“00”.
The pre-alarm feature will operate during the selected time-interval
before the preset alarm time.
To Next Page
Loading...
