A county can be subdivided as follows:
1 Northwest 2 North Central
3 Northeast 4 West Central
5 Central 6 East Central
7 Southwest 8 South Central
9 Southeast
TO RECEIVE ALL WARNINGS OR SPECIFIC LOCATION WARNINGS:
1.Press [COUNTY] to enter the county-code display from any clock display mode.
2.Press [UP VOLUME] or [ DOWN VOLUME] to select between receiving all [ALL] warnings or only
warnings from specified local areas.
NOTE: If specific local county is selected, that county code must to be programmed into the unit.
To enter the appropriate county code:
1.Press [COUNTY] to enter the county-code display from Clock-Display Mode.
2.Press [COUNTY] again to by-pass county-code field zero (0) and advance to county-code field one (1).
3.To enter the county code in this field, press and hold [COUNTY] for 2-seconds. The extreme left county-code
digit will flash.
4.To enter the first county-code digit, press [UP VOLUME] or [DOWN VOLUME].
REMEMBER: This part of the code subdivides a county into small localized sub-sections. If the
county’s code has not been subdivided into smaller sub-sections, select zero (0) in the
far left column.
5.To enter the remaining five (5) digits by following the same process. Press [COUNTY] followed by [UP
VOLUME] or [DOWN VOLUME].
6.When finished press [COUNTY] to advance to the next county-code field or wait 9-seconds to automatically
return to Clock-Display Mode.
To Next Page
Loading...
