Oriental motor BLHM450K Series - Names and Functions of Parts

6
Preparation
4.5 Names and functions of parts
This section explains the name and function for each part of the driver.
Motor connector (CN3)
LED (PWR/ALM)
Power supply connector (CN1)
I/O signal connector (CN2)
Internal potentiometer 1 (VR1)
Internal potentiometer 2 (VR2)
USB connector (CN4)
CN1 PWR/ALM VR2VR1 CN4CN2
+
-
CN3
Name Indication Description
Power supply connector CN1 Connects the power supply cable.
I/O signal connector CN2 Connects the I/O signal cable to connect with an external control device.
Motor connector CN3 Connects the motor cable.
USB connector CN4 Connects a PC in which the
MEXE02
has been installed.
LED PWR/ALM
Lit in green while the power is supplied.
If an alarm is generated, this LED will blink in red.
If information is generated, it will blink in orange.
Internal potentiometer
*
VR1
Uses to set the operation data.
Factory setting: The rotation speed in the operation data No.1 can be set.
VR2
Uses to set the operation data.
Factory setting: The acceleration time and deceleration time in the operation
data No.0 and No.1 can be set.
*
The function can be changed using the
MEXE02
.