Oriental motor DSC Series - General Specifications; Operating and Environmental Conditions; Storage and Shipping Conditions

General specications
−40−
12 General specications
Item Motor Speed controller
Operation
environment
Ambient
temperature
Single-phase 100V,
Single-phase 200V:
−10 to +50 °C [+14 to +122 °F]
(non-freezing)
Single-phase 110/115V,
Single-phase220/230V:
−10 to +40 °C [+14 to +104 °F]
(non-freezing)
0 to +50 °C [+32 to +122 °F]
(non-freezing)
Ambient
Humidity
85% or less (non-condensing)
Altitude Up to 1000 m (3300 ft.) above sea level
Surrounding
atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or
other special environment.
Vibration
Not subject to continuous vibrations or excessive impact
In conformance with JIS C 60068-2-6 "Sine-wave vibration test method"
Frequency range: 10 to 55 Hz
Pulsating amplitude: 0.15 mm (0.006 in.)
Sweep direction: 3 directions (X, Y, Z)
Number of sweeps: 20 times
Storage
environment
Ambient
temperature
−25 to +70 °C [−13 to +158 °F] (non-freezing)
Ambient
Humidity
85% or less (non-condensing)
Altitude Up to 3000 m (10000 ft.) above sea level
Surrounding
atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or
other special environment.
Shipping
environment
Ambient
temperature
−25 to +70 °C [−13 to +158 °F] (non-freezing)
Ambient
Humidity
85% or less (non-condensing)
Altitude Up to 3000 m (10000 ft.) above sea level
Surrounding
atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or
other special environment.
Degree of protection IP20