the Top Cross bar and attach the front bar on the other mounting
bracket. As one person holds the tower assembly you can now
assemble the rear bars.
NOTE: When you have a narrow boat you probably need to
shorten the Top Cross Bar to make the tower fit to your boat.
You are now ready to square up and center the loose assembly.
Have someone stand in front of the boat and determine that the tow
point is centered and the tower arms are symmetrical. Make
necessary adjustments.
Step 9
Drill through the predrilled holes in the center section from each side
with size 10 drill bit and install bolts and cap nuts. One person will
still be stabilizing the tower through this step. Tighten all hardware
for completion of tower installation.
To Next Page
Loading...
Need help?
General