Pop-Down Rubber Eyeguards
UltraView™ binoculars feature unique, rubber pop-down
eyeguards designed to block out stray light and allow easi-
er positioning of the eyes for viewing. When using the
binocular without eyeglasses, we recommend leaving the
eyeguards in the extended (up) position. For viewing with
eyeglasses on, retract each eyeguard by pressing it down
on one side of the eyepiece and then sliding your fingers
around to the opposite side while applying downward pres-
sure. With the eyeguards retracted (down), your eyes can
be positioned closer to the eyepiece lenses for an improved
field of view.
Mounting Your Binoculars
on a Tripod
For steadier or extended viewing, you can mount your
UltraView™ binocular on any standard camera tripod by
means of an optional “L”-bracket (available from most
binocular dealers). Unscrew the small cap bearing the
white tripod symbol located at the front of the center shaft,
between the two binocular barrels. Removing this cap
reveals a 1/4"-20 threaded hole into which the top end of
the L-bracket is inserted. The bottom end of the L-bracket
is threaded onto the tripod itself.
To Next Page
Loading...
Need help?
General