English - 70 -
After APS is fi nalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers and
names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via
the program table.
Do not turn off the TV while initializing firs time
installation
Input Selection
Once you have connected external systems
to your TV, you can switch to different input
sources.
• Press SOURCE button on your remote control
for directly changing sources.
or,
• Select “Source” option from the main menu
by using “
” or “ ” button. Use then “ ” or
“ ” button to highlight an input and press “
” button to select.
Note : You can mark desired source options by
pressing the OK button. Therefore, when SOURCE
button is pressed, only the marked source options will
be available (except for the TV source).
Basic Operations
You can operate your TV using both the
remote control and onset buttons.
Operation with the Buttons on the TV
Volume Setting
• Press “
” button to decrease volume or
button to increase volume, so a volume
level scale (slider) will be displayed on the
screen.
Programme Selection
• Press “ P/CH + ” button to select the next
programme or “ P/CH - ” button to select the
previous programme.
Viewing Main Menu
• Note: Press “
” /“ ” buttons at the
same time to view main menu. In the Main
menu select sub-menu using “ P/CH - ” or
“ P/CH + ” buttons and enter the sub-menu
using “ ” or “ ” buttons. To learn the
usage of the menus, refer to the menu system
sections.
AV Mode
• Press the “ TV/AV ” button in the control panel
on the TV to switch between AV modes.
Operation with the Remote Control
• The remote control of your TV is designed
to control all the functions of the model you
selected. The functions will be described in
accordance with the menu system of your
TV.
• Functions of the menu system are described
in the following sections.
Volume Setting
• Press V+ button to increase the volume. Press
V- button to decrease the volume. A volume
level scale (slider) will be displayed on the
screen.
Programme Selection (Previous or Next
Programme)
• Press “ P - ” button to select the previous
programme.
• Press “ P + ” button to select the next
programme.
02_MB25_(SSM) [GB]_ (01-TV)_22875W_1900UK-ANALOG-NICKEL5-10061913_50143494.indd 1802_MB25_(SSM) [GB]_ (01-TV)_22875W_1900UK-ANALOG-NICKEL5-10061913_50143494.indd 18 25.02.2009 15:33:4425.02.2009 15:33:44
To Next Page
Loading...
