Auto mode - continuously drying mode-sleeping mode cycle, press once to switch the mode from
one to another, the corresponding indicator lights up.
Auto mode: when e nvironmental humidity ≥ set humidity +3%, the fan starts working and
compressor starts working after 3 seconds.
When environmental humidity ≤ set humidity -3%, the compressor stops working and and the fan
delay shutdown.
Both fan speed and humidity ca n be adjusted under auto mode.
Continuously drying mode: The machine continues to run, but the humidity can not be
Sleeping mode: Touch the sleep button, the button lights up and start the sleep function.
After no operation in 10 seconds, all indicators turns dark gradually a nd the wind spee d is
automatically switched from high to low. Touch any button to wake up the indicator. Touch sleep
button again to exit the sleep mode.
In sleep mode, the fault code is not displayed, the wind speed is not adjustable, and the humidity
is adjustable.
In automatic mode or sleep mode, you can operate this key to adjust the set humidity: every time
you press the set humidity increase by 5%, according to the cycle of 30%-80%.
Long press this key to query the current room temperature, double eight lights display the current
room temperature 5 seconds after the automatic return to display the current humidity. If this key
is pressed for a long time, it will be display the ambient temperature.
Press this key to set the timer function of 0-24 hours. The interval is 1 hour. Each time you press
this button, the value increased 1 hours and then the corresponding timing value is displayed on
the screen. The setting value is “00” to cancel the timer function. The indicator turns out.
After the timer is set and completed, the timer LED is on during the timing period. After the timing
is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine;
in the standby state, set the time to turn on the machine.
To Next Page
Loading...