33
PC/HDMI
AUDIO
PC MONITOR
PC connection
As PCs are sometimes supplied with a ‘conventional’ CRT monitor, you may need to adjust the display
settings of your PC’s graphics card, otherwise the pictures may not appear correctly. Switch on your PC (still
with your original monitor) - select ‘1360 x 768’ for the screen resolution, and select 60 Hz for the on-screen
refresh rate. Switch off your PC, then connect it to your LCD TV while both items are still switched off.
Use a PC-VGA cable (not supplied) to connect the LCD-Monitor
to your PC. Make the connections carefully so as not to break or
bend the contacts inside the plug.
Select PC input
Switch on the LCD-TV.
Select the PC input mode (see page 12).
Note:
If there is no video signal from the
computer when the unit is in PC
mode, “NO SIGNAL” will appear on
the TV screen.
Monitor Display modes
MODE Resolution Refresh rate
VGA 640x480 60Hz
VGA 720x400 70Hz
SVGA 800x600 60Hz
XGA 1024x768 60Hz
WXGA 1280x720 60Hz
WXGA 1280x768 60Hz
WXGA 1360x768 60Hz
(according to Graphic card)
•
Note:
Digital PC-connection via HDMI input
is not supported.
If you try to connect your PC digitally
anyway, the TV-operation might
freeze. TV will stop to respond
properly on usercommands.
Countermeasure: Switch-off your
TV and disconnect from the 230V-
power-supply.
Disconnect the digital PCconnection.
Now you may retry operating your TV.
If a digital PC-connection does show
a picture, proper working is not
guaranteed. Digital PCconnection is
not granted for this TV.
•
•
Description about the each setting option:
PICTURE Menu
BRIGHTNESS and CONTRAST: You can adjust
these according to to your personal preferences.
HOR POSITION and VER POSITION: to adjust the
horizontal and vertical placing of the image.
PHASE and CLOCK: eliminates the horizontal
(PHASE) and vertical (CLOCK) interfering lines.
RED/GREEN/BLUE: influences the colour balance.
BACKLIGHT: Press
or to adjust the level you
require.
WXGA INPUT: When you input an WXGA signal,
set this option to “ON”.
RESET: Press ENTER to reset BRIGHTNESS,
CONTRAST, RED, GREEN and BLUE to the factory
preset values.
AUDIO Menu
BASS/TREBLE/BALANCE: Tone setting menu.
RESET: Press ENTER to reset BASS, TREBLE and
BALANCE to the factory preset values.
Example: Adjust the contrast.
1
During PC mode press ANALOG
MENU.
The Menu will appear on the screen.
BRIGHTNESS 25
CONTRAST 40
HOR POSITION 0
VER POSITION
PHASE 25
CLOCK
0
0
2
Select CONTRAST, then press ENTER. Press or to
adjust CONTRAST.
3
Press EXIT to return to the normal screen.
VGA cable
(not supplied)
Audio cable
(not supplied)
PC
TV
(Left side view)
to PC/
HDMI
AUDIO
input
32G0146B_ENG.indd 3332G0146B_ENG.indd 33 10/11/07 1:52:32 PM10/11/07 1:52:32 PM
To Next Page
Loading...
