Orion XTREME 200 - Low-Pass Crossover Operation; SIGNAL INPUT AND OUTPUT LEVEL CONTROLS; Front and Rear Level Adjustments

OUTPUT CONFIGURATIONS
Three position switches determine output configuration for the XTREME amplifiers. Each stereo pair of channels can be configured in either stereo,
summed-bridged and bridged-mono. The switch or switches are located on he outermost edge of the amplifier.
When the switch is in the left position, the output channels are configured for stereo operation.
When the switch is in the center position, the output channels are configured for summed mono operation by
mixing the left and right input signals together.
When the switch is in the right position, the output channels are configured for a single bridged output using a
single RCA input. To determine which RCA to use, refer to the marking in parenthesis. For the front outputs, the
Right RCA input is used. For the rear outputs, the Left RCA input is used.
page 27