Orla Jamkey - Split and Pedal Configuration; Editing Split Settings; Bass Pedal Configuration

To Next Page

To Previous Page

There are three sections (Split) available for the Upper and three sections (Split) for the

Lower.

For each Split you can edit the following: Split Name, Split ON/OFF, Start/Stop Key, Midi

Channel, Transmit, Octave Transpose, Semitone Transpose, Velocity Curve, Bank MSB –

LSB.

To activate the following parameters (Program Change, Volume, Send Reverb, Send

Chorus, Fixed Velocity, Midi Out ports (standard Midi Out and USB1 Midi Out) simply

select the function by ticking the related check box.

Bass Pedals

You can connect a midi bass pedal board via MIDI IN located in the rear connection panel.

There is one section available for the Bass Pedal and the following parameter can be

edited: Split Name, Split ON/OFF, Start/Stop Key, Midi Channel Transmit, Midi Channel

Receive, Octave Transpose, Semitone Transpose, Velocity Curve, Bank MSB–LSB.

To activate the following parameters: Program Change, Volume, Send Reverb, Send