- 19 -
EN
Size class
Installation
direction
Installation Type Child safety device
40-105 cm
Rear-
facing
Isofi x connectors
& Top-Tether
i-Size
5-point seatbelt for the child
seat
76-105 cm
Forward-
facing
Isofi x connectors
& Top-Tether
i-Size
5-point seatbelt for the child
seat
100-150 cm
Forward-
facing
Isofi x connectors
& 3-point car seat
belt
i-Size
Booster
seat
3-point car seat belt
100-150 cm
Forward-
facing
3-point car seat
belt
i-Size
Booster
seat
3-point car seat belt
The following table provides information about the fastening devices and methods:
1. & 2.:
40-105 cm: Only if Isofi x connectors and a fastening hook
for the top tether are available. For rear-facing use addi-
tionally only if the airbag can be deactivated.
100-150 cm: Only if at least a 3-point belt that complies
with ECE R16 is available. If Isofi x connectors are available,
these can also be used. Securing the child only with a
2-point belt is not approved.
NOTE (100-150 cm):
This is an optimised i-Size children’s booster seat. It is approved under Regulation no. 129 for use
primarily in “i-Size vehicle seats” as specifi ed by vehicle manufacturers in the vehicle owner’s man-
ual. If in doubt, contact either the manufacturer of the extended child restraint system or the dealer.
The optimised i-Size booster seat can also be used on all seats in the “universal” category, as long
as this does not confl ict with the vehicle interior.
If you have any doubts, please contact the car seat manufacturer or the retailer.