EN
Fastening the safety seat buckle
1. Slot the two metals secons of the buckle connectors together.
2. Slot the two buckle connectors into the slot in the top of the buckle unl they ”click” into place.
3. Always check the harness is correctly locked by pulling the shoulder straps upwards.
4. To release the harness, press the red buon on the buckle downwards.
Tightening the harness
Slackening the harness
Pull the shoulder straps upwards to remove the slack from the lap
secons of the harness, then pull the adjuster strap unl the harness
is fully ghtened.
The harness should be adjusted as ghtly as possible without causing
discomfort to your child.
Ensure that the lap strap poron of the harness is located as low as
possible towards the thighs – not around the tummy.
A loose harness can be dangerous. Check the harness adjustment
and ghten each me the child is placed in the seat.
The harness is slackened by pressing the lever (under the seat co-
ver) on the front of the seat.
Press down on the label marked ”PRESS” as you grip the two shoulder
straps with your other hand. Pull the shoulder straps towards you to
loosen the harness.
Take care when you adjust the shoulder straps that you do not trap
the harness adjuster straps as you press the lever down.
To Next Page
Loading...
