osann LUPO PLUS - Fitting Car Seat for 9-18 kg

EN
Fing the car seat for 9-18 kg with the 3-point-seat belt
1. 2.
3.
4. 5.
1. Place the child safety seat on the vehicle‘s seat ensuring it is rmly pressed against the car seat back-
rest.
2. Thread the car seat belt in through the seat belt route slot in the seat‘s plasc backrest furthes from
the car‘s seat belt buckle, and the out through the other seat belt route slot and fasten it into the
seat belt buckle.
3. Check the webbing of the seat belt has not become twisted or tangled and that the lap belt goes
under the armrest and the diagonal belt under the headrest belt guide then goes over the red belt
guide on the side of the backrest.
4. Place your knee on the base of the safety seat and grip the top piece of seatbelt webbing. Pull the
webbing upwards to ghten the seat belt.
5. Finish ghtening the webbing by pulling the diagonal strap upwards unl there is no slack and the
seat is held rmly in place. Now you can strap your child into the seat.
Make sure the seat belt has not become twisted.
To release your child seat follow the above instrucons in reverse order.