OSCAR ONE Series - Cables and pin description

4.2. Cables and pin description
Power cable (3 pin)
Make sure you have a separate switch available on your panel to be able to
switch the system on & off.
Power supply 12V DC
Attention: Incorrect “+” and “-“ can damage the system. Make sure the power
supply is secured with a fuse (max 5A).
Wire 1
VCC
Wire 2
GND
Wire 3 / green-yellow
External Buzzer
Mast data cable (6 pin)
The mast data cable is connected to the OSCAR One unit on the top of the mast
and to the Y-cable inside the boat. Refer to this video
https://www.youtube.com/watch?v=DEre-SzwMt0 for assembling the bottom
connector.
The mast data cable contains ethernet (4 pin) and NMEA 2000 backbone.
(Backbone termination-resistor is inside Oscar One.)
cable wire
pin number
connector front view
brown
1
white
2
green
3
yellow
4
grey
5
pink
6
shield
7
shield
8
BSB GROUP I www.oscar-navigation.com I Page 12 of 16