4.4. External Buzzer
OSCAR One has an in-built switch to control an external buzzer.
The external buzzer needs to be continuous in order to correctly reflect alarm
intervals generated by OSCAR One.
Connect the “+” pin of the buzzer to the power supply and the ground pin to
wire 3 of the power cable.
ATTENTION: max. current: 1 A, max. voltage 24 V
5. Setup OSCAR One
5.1. Preparation
o OSCAR: Serial Password (sent by e-mail)
o Height of Vision Unit (see chapter Preparation)
o Horizontal distance from mast / signal mast to bow (+/- 1 m) (see chapter
Preparation)
o Mast rake in degrees °(see chapter Preparation)
o Boatswain’s chair, 2x Wrench Size 8 mm
To Next Page
Loading...