2.2. Tools needed for hardware installation
o OSCAR system incl. card with your personal OSCAR-WiFi and Serial
Password
o Allen key 2.5 mm
o Wrench Size 10 mm + 8 mm
o Torx Wrench T15 + Torx T10H
o Bolt Adhesive Medium: Loctite 243
o Torque wrench (flange & screws) 1.2 Nm – 5 Nm
o Drilling machine + Drill bit Ø 2 mm and Ø 6 mm
o 4x Screws M6 for adjustable fixing bracket
o 1 Network cable minimum CAT5e incl. 1x TE Mini I/O plug & 1x Amphenol
circular connector to connect Vision Unit with Processing Unit
o 1 power cable incl. 1x Switchcraft hollow plug in the length to connect
Processing Unit with control panel
o 1 power cable with a cross section of one wire of 1.5 mm² incl. 1x
Switchcraft hollow plug & 1x Amphenol circular connector in the length
to connect Vision Unit with Processing Unit
o NMEA 2000 cable (Boat bus to Processing Unit)
o Boatswain’s chair
o Ruler, Marker/Pencil, cable ties
To Next Page
Loading...