What to do if my OSI Metal Detector unit does not start?
If your OSI Metal Detector unit isn't starting, first ensure the mains are properly connected by checking the power connections. Then, verify that the power switch is turned on. If the issue persists, it could be due to faulty electronics, requiring a service call.
How to troubleshoot no power to the electronics in my OSI Rapiscan Orion Metor 900M Metal Detector?
If there's no power to the electronics of your OSI Metal Detector, begin by checking the power cable connections to ensure they are secure. If the problem continues, it could indicate a faulty power supply, in which case you should call service.
Why is my OSI Rapiscan Orion Metor 900M Metal Detector showing a high interference level?
A high interference level in your OSI Metal Detector might be due to several factors. The selected frequency may not be suitable for the environment; try changing the operating frequency. An interference source might be too close to the unit; remove the source or relocate the unit. Large moving metal nearby could also be the cause; increase the distance between the unit and the metal. Additionally, floor vibrations from people walking by can cause interference; improve the floor's support or relocate the unit.
What causes random alarming in an OSI Metal Detector and how to fix it?
Random alarming in your OSI Metal Detector is often due to external interference. To resolve this, try changing the operating frequency, relocating the unit, or reducing the sensitivity.
General| Application | Security screening |
|---|---|
| Type | Walk-through |
| Detection Technology | Electromagnetic |
| Weight | 68 kg |
| Power Supply | 100-240 VAC, 50/60 Hz |
To Next Page