OSMC offers a one year warranty for this product. This OSMC limited warranty covers your Vero
hardware product, along with any accessories received with the hardware product, (“Warranted
Product”) under normal use conditions for manufacturing defects or hardware component failures in
your Warranted Product that is still within warranty. Accessories sold separately are covered by the
applicable warranty accompanying the accessory. This warranty is for the original owner only and
cannot be transferred to another party (including a buyer of a used Warranted Product). If you give or
sell the Warranted Product, this Limited Warranty will end although this does not affect any rights that
the new owner has under applicable consumer laws.
OSMC will repair, or if repair is not reasonably possible, replace your defective Warranted Product.
Replacement parts and/or products may include new or refurbished parts or products and are
warranted only until the expiration of the original Warranty Period.
This does not affect any rights that you have under applicable consumer laws including the right to
claim a refund.
OSMC is not responsible for any interoperability or compatibility issues that may arise when (a)
products, sotware, or options not supplied or supported by OSMC are used; (b) configurations not
supported, provided or approved by OSMC are used; (c) parts intended for one system are installed in
another system of a different make or model.
FCC and CE Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diferent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the EMC Directive 2004/108/EC and Low
Voltage Directive 2006/95/EC.
Warranty InformationSafety Information
To Next Page
Loading...