To Next PageTo Next PageWhy is there no hot water from my OSO HOTWATER Saga-S?
If you have no hot water from your OSO HOTWATER Water Heater, first, ensure that the fuse is on, the plug is properly connected, and the earth breaker hasn't tripped. If the issue persists, the thermostat may have cut out; try pressing the ‘RESET’ button on the safety thermostat. A defective heating element or a leak in the hot water pipe could also be the cause.
Why is my OSO HOTWATER Saga-S leaking?
If you notice leakage or dripping from the safety valve of your OSO HOTWATER Water Heater, or water on the floor near the cylinder, it could be due to several reasons. The water pressure entering your home might be too high, or the safety valve may be worn or have particles stuck in it. Alternatively, there could be a leak from the heating element.
What to do if my OSO HOTWATER Saga-S Water Heater doesn't provide enough hot water?
If your OSO HOTWATER Water Heater isn't providing enough hot water, it might be due to high consumption in your home. You can try raising the temperature on the thermostat to 85°C.
Why does the fuse/earth breaker trip repeatedly with my OSO HOTWATER Saga-S?
If the fuse or earth breaker trips repeatedly when using your OSO HOTWATER Water Heater, there might be a fault in the heater’s electrical system. You can check the junction box for any visible problems.
Why does it take so long for the water to reach the tap from my OSO HOTWATER Water Heater?
If the water takes a long time to reach the tap from your OSO HOTWATER Water Heater, it's likely due to a long stretch of pipe between the heater and the tap.
General| Brand | OSO HOTWATER |
|---|---|
| Model | Saga-S Series |
| Category | Water Heater |
| Language | English |
