EXOS | EJA
8
SIZING / FIT
PACK FIT INSTRUCTIONS (CONTINUED)
6 CHECK TORSO LENGTH
Locate the harness yoke – this is where the harness straps come together near the base of the user’s neck.
Locate the C7 vertebra – the large protruding bone at the base of the neck. The yoke should be 1 in./2.5 cm.
- 2 in./5 cm. below the C7 vertebra.
7 ADJUSTABLE HARNESS (TORSO LENGTH)
a. Identify the harness plugs located in one of the four sizing loops on the backpanel.
b. Grab the plug's pull loop with thumb and forefinger and pull the harness's LightWire extension out and to the sides
of the pack. This releases the harness and allows it to slide up and down.
c. Slide the harness up or down along the LightWire rails to the appropriate torso length.
d. There are two load-lifter ladder lock options. Correspond the lower two or upper two backpanel settings to the
lower or upper load-lifter ladder lock
8 STERNUM STRAP
Adjust the sternum strap to approximately 2"/5 cm below the collarbone; buckle and tighten to tension
To Next Page
Loading...
