6
9. Lateral Bar Adjustment:
Side bars may be bent to fit individual anatomies as shown. Side
bars must be bent with final length adjustment completed. Bend
with bending irons.
NECK STRAP APPLICATION:
10.Attach the D-Ring to the strap closest to the wrist.
11. Place the neck strap over the opposite shoulder of the injured
arm and across the back and under the unharmed arm.
12. Use the clip to attach the free end of the neck strap to the
brace.
13. Unattach the loop of the free end and raise it to a
comfortable position.
Reattach the hook piece. Slide the neck strap pad over the
shoulder so the neck strap feels comfortable.
14. Removal and Re-application:
To remove the Innovator X™, unfasten the straps and loosen the
cuffs. The brace can then be removed and reapplied using one
hand as a single unit.
WASHING INSTRUCTIONS
This product can be washed at any time by hand using a mild
detergent and cold water.
Do not use bleach or strong detergent. Do not wash in washing
machine or place in dryer. Air/line dry only. Do not heat dry.
To Next Page
Loading...
Need help?
General
