Oster ELECTRIC WOK - Learning About Your Electric Wok; Electric Wok Components

www.oster.ca
www.oster.ca
5
4
LEARNING ABOUT YOUR
ELECTRIC WOK
Lid Handle
Removable Glass Lid
Handle
Temperature Control Probe
Temperature Control Dial
Base
DuraCeramic
TM
Non-Stick
Cooking Surface
a e
b f
c g
d
This appliance features a DuraCeramic™ non-stick natural
ceramic coating which is 4X more durable (won’t peel or
ake) than other non-stick coatings. Furthermore, the
ultra-durable ceramic coating cooks faster than other
non-stick coatings, saving time and energy. The natural
DuraCeramic
TM
non-stick coating also oers greater health
and benets as it’s free of PTFE and PFOA. 4X More Durable
– DuraCeramic™ non-stick coating!
Congratulations on your purchase of an Oster® appliance with
DuraCeramic™ non-stick coating!
HOW TO:
Introduction
Before using your new appliance, wash the inside of the pan
with warm, soapy water and dry. When washing the wok, make
sure the temperature controller is removed.
The OSTER® Electric Wok is now ready for use.
How To Use Your Electric Wok
1. Set your Wok on a at, dry, heat resistant surface.
2. Set the TEMPERATURE CONTROL DIAL to OFF and plug the
TEMPERATURE CONTROL PROBE into BASE of your Wok.
3. Plug the CORD into a 120V power outlet.
4. Set the TEMPERATURE CONTROL DIAL to the desired
temperature setting by aligning the temperature on the
TEMPERATURE CONTROL DIAL with the thermostat light. This
light will remain on until the set temperature has been
reached and then will cycle on and o throughout cooking,
as the cooking temperature is maintained by the thermostat.
NOTE: On initial heating of your Wok, it is recommended that
the temperature be allowed to cycle (the light glowing on and
o) several times. This will help the NON-STICK COOKING
SURFACE to adjust to a more accurate cooking temperature.
5. Use the GLASS LID when a moist-heat cooking method is
desired.
CAUTION: Your Wok is hot! Use hot pads or oven mitts.
6. After food is cooked, set the TEMPERATURE CONTROL DIAL to
the WARM setting until ready to serve, or to OFF if food is
removed immediately.
7. After cooking, turn the TEMPERATURE CONTROL DIAL to OFF.
Unplug the CORD from wall outlet. After your Wok has
cooled, remove the TEMPERATURE CONTROL PROBE.
CAUTION: The TEMPERATURE CONTROL PROBE may be hot.
c
a
b
d
e
g
f
c
CKSTWK99SB-033_13EFM1.indd 4-5 11/25/13 9:17 AM