English-9
As the rinse aid diminishes, the size of the black dot on the rinse aid level indicator
changes, as illustrated below.
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
Pour the rinse aid into the dispenser, be careful not to overfill.
Replace the cap by inserting it aligned with "open" arrow and turning it to the "closed"
(right) arrow
The rinse aid is released during the final rinse to prevent water from forming droplets on
your dishes that can leave spots and streaks. It also improves drying by allowing water to
sheet off the dishes. Your dishwashers are designed to use liquid rinse aids. The rinse aid
dispenser is located inside the door next to the detergent dispenser.
To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level
indicator turns completely black. The volume of the rinse aid container is about 140ml.
Be careful not to overfill the dispenser, because this could cause over sudsing. Wipe away
any spills with a damp cloth. Don't forget to replace the cap before you close dishwasher
door.
Attention!
Clean up any rinse aid split during filling with an absorbent cloth to avoid excess foaming
during the next wash.
Please observe the manufacturer's dosing and storage recommendations as stated
on the detergent packaging.
Close the lid and press until it locks in place. If the dishes are heavily soiled, place an
additional detergent dose in the pre-wash detergent chamber. This detergent will take
effect during the pre-wash phase.
NOTE:
You find information about the amount of detergent for the single programme on the
last page.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty
D (Rinse-Aid indicator)
RINSE AID DISPENSER
2
1
3
1
2
3
4
5
6
M A X
To Next Page
Loading...
