PAGE 3 OF 3
OSTER PRO3000i
Trouble Shooting
Malfunction Cause Rectification
Top blade does not move
Clipperhead is not well engaged Engage the clipperhead correctly when the motor is running
Drive lever is defective Replace drive carrier (*)
Clipper cuts badly or not at all
Clipper blade is blunt Have top and bottom blades resharpenend by service center (*)
Clipper blades have not been correctly ground Have top and bottom blades resharpenend by service center (*)
Clipper blades are not oiled Oil clipper blades every 15 minutes
The animal‘s hair is wet Only clip dry hair
Hairs jammed between top and bottom blades
Take off clipperhead, push the top blade half away from the clipperhead, take away
hairs between top and bottom blade
Clipperhead has too little clipping pressure Have clipperhead inspected (*)
Motor is not running
Battery flat Charge battery
Contacts dirty Switch clipper off and clean the contacts
Faulty battery Replace battery (*)
Smell of burning from the motor housing. Motor burned out. Have motor and / or electronics replaced (*)
Motor and / or electronics faulty Have motor and / or electronics replaced (*)
Clipperhead blocked Clean and oil clipperhead
Motor runs very slowly Clipper blades were not oiled sufficiently Oil clipper blades
Running time of a fully charged battery is
too short and / or blades are getting hot
Clipper blades were not oiled sufficiently Oil clipper blades
Flat, not fully charged or faulty battery is being used Only use intact, fully charged original batteries
The control light of the charging station in not on
Charging station is not connected to the power supply Connect the charging station to the power supply
Charging station is faulty Have charging station inspected (*)
When charging flat battery the light does
not change from green to red
Contacts dirty Clean contacts
Faulty battery? Replace battery (*)
Contacts of the charging station are deformed Have the charging station repaired (*)
To Previous Page
Loading...