12
About Start-up Handling Warnings More info
Press and hold all three buttons, (+),
(-) and (o) for 5 seconds. The status
light will flash green twice.
The status light will light up green
for about 10 seconds to confirm the
remote is ready for pairing.
Restart the hearing aids to activate
pairing mode.
To turn the hearing aids OFF and ON
again, see your hearing aid‘s
instructions for use.
Wait for about 10 seconds – until the
hearing aids are fully turned on and a
jingle has been played which indicates
that the power is on. The hearing aids
will remain in pairing mode for
3 minutes.
1. Prepare for pairing 2. Put hearing aids in
pairing mode
To Next Page
Loading...