Change program
Pair your hearing aids with the TV Adapter
Before using the TV adapter, it must be paired with your hearing aids.
Pairing is only required once and takes around 20-60 seconds.
1. Make sure the TV adapter is on (plugged in).
2. Open and close the battery door on (both of) your hearing aid(s).
3. Place both hearing aids close to, or on top of, the TV Adapter.
4. Pairing is completed when the Power Indicator and TV Indicator
lights turn steady blue for about 30 seconds.
5. Your hearing aids are now able to receive sound streaming
from the TV adapter.
Alternatively, you can also start
TV sound and adjust volume with
the optional hearing aid Remote
Control 3.0 accessory.
Start TV sound
using your hearing aids
To listen to TV, simply make long
presses on the button on your
hearing aids to cycle through the
programs until you reach the TV
listening program. The program
cycle will depend on how many
programs have already been set
up in your hearing aids by your
hearing care professional.
To stop the sound from the TV,
simply cycle back to the desired
program in your hearing aids.
Note: The optional Oticon ON App also lets you access
the TV listening program and adjust volume control.
P2 TVP1
Change program
A short press on the RIGHT
hearing aid button increases
the volume.
A short press on the LEFT
hearing aid button decreases
the volume.
P2 TVP1
Adjust the volume by pressing
up or down briefly. Repeat
the brief press for further
adjustments.
Connect the TV Adapter 3.0 box to your television
See the Instructions for Use booklet that comes with the TV adapter.
Four methods are available to support a wide variety of connection needs.
Using TV Adapter 3.0
1
2
3
4
To Next Page
Need help?
General
