EN
28
Installing the SIM/micro card and battery:
Switch your phone off before installing the card and
the battery.
1. Remove the back cover and battery.
2. Set up the SIM card as shown on the phone
and slide it slightly into the slots of the SIM cards.
3. Insert the memory card into the slot as shown on
your device.
4. Insert the battery with the contacts facing
against the contacts on the phone. Slide gently
the battery in until it locks. Remember to remove
the cover from the battery contact if it is present.
Replace carefully the back cover of the phone,
until you hear, it snaps.
Charging the battery:
Before putting your phone into service you must
recharge its battery.
1. Connect the adapter to the charger. Take care
of the good micro-USB connector orientation. Do
not use violence when attaching into the phone.
2. Connect the charger to the wall outlet.
3. If the battery is fully charged, disconnect the
phone from the charger.
Switching the phone on/ off/ sleep mode:
Make sure that the phone has a SIM card and the
battery is fully charged.
Press the ON button to switch on the phone.
To Next Page
Loading...
