8
This device complies with part 15 of the FCC Rules. Operation is subject
to the condition that this desvice does not cause harmful interferene Any
changes or modifications not expressly approved by the party responsible
forcompliance could void the uer’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. lf this equipment does cause harmful
interference to radio or television reception,which can be \ determined by
turning the equipment off and on , the user is encouraged to try to correct
the interference by one or more of the followingmeasures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit differentfrom that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/T technician for help.
Specific Absorption Rate ( SAR ) information:
This Mobile Phone meets the government's requirements for exposure to
radio waves . Theguidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies . The standardsinclude a substantial safety
margin designed to assure the safety of all persons regardlessof age or
healthrequirements , use accessories that maintain a 10mm separation
distance between the users body and the back of the handset . The use of
belt clips, holsters and similaraccessories should not contain metallic
components in its assembly. The use ofaccessories that do not satisfy
these requirements may not comply with FCC RF exposureequirements,
and should be avoidedBody-worn Operation his device was tested for
typical body-worn operations. To comply with RF exposurerequirements,
a minimum separation distance of 10mm must be maintained between
theusers body and the handset, including the antenna. Third-party belt-clips,
holsters, and similar accessories used by this device should not contain any
metallic components Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
FCC ID : 2ANMU-WP50
To Next Page
Loading...
