EN
31
Installation of NANO SIM and microSD cards
Turn off your phone before installing cards.
1. Open the card slot covers and carefully pull out
the SIM or microSD card slots on the sides of the
phone using the SIM card clip provided in the
giftbox.
Insert the cards into the drawer until they fit into
its place, and then insert the drawers back into the
phone.
2. Make sure that the covers are closed properly.
3. It is possible to use 2x NANO SIM or 1x NANO
SIM and 1x microSD card in the phone.
Charging the battery:
Before using the phone for the first time, you must
first charge the battery to 100%.
1. Connect the adapter to the charger. Please do
not use violence, when plugging the connector.
Keep plugging the micro-USB connector from the
correct side.
2. Connect the charger to a wall outlet.
3. When the battery is fully charged, disconnect the
phone from the charger.
Switching the phone on / off / sleep mode
Make sure that the phone has a SIM card and the
battery is fully charged.
Press and hold the ON/OFF button to switch on the
phone.
To Next Page
Loading...
