EasyManua.ls Logo

Outback Logic Siesta 4 - Tent Setup Guide; Step-by-Step Assembly; Using Your Tent for Comfort

Default Icon
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Outback Logic 2016 3 outbacklogic.com
PLEASE READ THESE INSTRUCTIONS CAREFULLY, EVEN IF YOURE
AN EXPERIENCED CAMPER OR TENT-NINJA. THIS TENT HAS
SOME UNIQUE FEATURES, CARE AND SAFETY REQUIREMENTS
NOT FOUND IN OTHER TENTS.
The Siesta
4
is supplied with the inner tent already clipped into the y. This makes for quickest setup, but
it is recommended to use two people so as to avoid unnecessary stress on poles. If you intend to setup
with one person in future, we recommend leaving the inner tent unclipped when you pack the tent way.
1. Lay the tent out at and evenly with the reecve y facing upwards and the black oor fabric
against the ground.
2. Adjust the y fabric so that the black pole sleeves of the dome form an X, and are as straight as pos-
sible.
3. Assemble the poles and lay them to one side. Idenfy the two longest poles.
4. Insert the two longest poles through the black pole sleeves of the dome. Always push the pole gen-
tly. Dont pull or force.
5. Keeping the poles at, clip one end of each pole into the grommet in each corner. Use the grommet
nearest the centre for the dome poles.
6. Posion one person at the other end of each pole and locate the corner strap.
7. Push both poles together so the dome pops-up and clip the pole end into the grommet.
8. Repeat the process with the vesbule poles, using the outer grommets.
9. Stake out the corners of the dome (4 stakes).
10. Stake out the vesbules (4 stakes).
11. Stake out guy ropes (8 stakes).
Note: There are 4 oponal guy-out points on each side of the tent. Extra ropes and stakes are not includ-
ed, but are recommended in high winds.
USING YOUR TENT
To provide maximum comfort in sunny weather and minimise the temperature inside the tent, follow
these recommendaons:
1. Always open the roof vents.
2. Always open the vesbule corner vents
3. Even if fans are not in use, always open the side vents.
4. Aach the circular side-vent ducts to the inner tent. A head-lamp or lantern is recommended so
both hands are free. Take your me to carefully work your way around the circumference of the
vent. Line up and push together the hook & loop strips so an even seal is made all the way around.
5. Depending on the lay of the land and the tension of your tent pitch, you may wish to use the extra
side-vent poles to maximise the opening of the side vent. To do this, aach the extra pole
(kickstand) in between the two sewn-in kickstands’.
TIP: The doors have loops on the inside so you can hook the doors parally open to increase venlaon
whilst liming the amount of light. If the tent is warming up try opening both doors 1/4 way, or 1/2 way.
To use the door loops from the inside, unzip the door fully, clip the loops through the toggles at the re-
quired height, then then close the zippers gently unl the door is tensioned.
SETUP