Need help?Do you have a question about the Outdoor Tech CHIPS 3.0 and is the answer not in the manual?
General| Bluetooth Version | 5.0 |
|---|---|
| Wireless Range | 33 feet |
| Charging Time | 2 hours |
| Built-in Microphone | Yes |
| Driver Size | 40 mm |
| Frequency Response | 20Hz - 20kHz |
| Impedance | 32 ohms |
| Connection | Bluetooth |
| Type | Bluetooth Headset |
Identifies the primary control buttons on both the left and right ear pieces.
Details the location of the USB-C charging port and the LED status light.
Specifies the location of the built-in microphone for calls and voice commands.
Explains how to power on, play/pause, skip tracks, manage calls, and activate voice assistants.
Details powering off, adjusting volume, muting the microphone, and activating voice assistants.
Instructions for fully charging the device using the provided USB-C cable before first use.
Describes how the LED light indicates battery level and charging status.
Steps to put the wireless helmet audio into pairing mode for connection.
Guidance on selecting 'ODT Chips 3.0' in phone settings and confirming the connection.
Instructions on answering, ending, rejecting calls, and making new calls.
How to use voice commands and adjust audio volume during calls.
Instructions on how to properly place the CHIPS 3.0 into helmet liner slots.
Tips for listening to music and making calls while skiing or snowboarding.
Details on battery performance, Bluetooth version, and supported profiles.
Information on operating distance, charging input, dimensions, and weight.
Solutions for red LED flashing twice or not turning on during charging.
Guidance for resolving pairing failures and Bluetooth signal loss.
Tips for when the device can't hear voice input or has volume issues.
Recommendations for keeping the CHIPS dry and away from extreme temperatures.
Advice against disassembly, dropping, and using harsh cleaning agents.
To Next Page
