Outdoor Tech TURTLE SHELL 3.0 - Pairing Your Device; Powering On;Off and Pairing Mode; Connecting to a Device

PAIRING TO DEVICE
Enter Pairing Mode
When powered on hold the “+” and “-” at the
simultaneously for 2-3 seconds or until you see the
LED light flash blue 3 times and the voice prompt
states “Pairing.”
Pairing Turtle Shell 3.0 to Device
Open the Bluetooth settings on your device. If you
have put your Turtle Shell
®
3.0 into pairing mode,
it should be listed as “ODT Turtle Shell
®
3.0” as an
available device to pair. Connect with the Turtle
Shell
®
3.0 and enter “0000” if prompted. The voice
prompt will state “Successful” if the Turtle Shell 3.0
and your device connect.
Power On / Off
ON: Hold the Power Button for 2-3 seconds or until
the LED light flashes blue and the voice prompt
states “Power on”
OFF: Hold the Power Button for 3-4 seconds or
until the LED light flashes red and the voice prompt
states “Power off”