EasyManuals Logo

Outsunny C00-034V91 User Manual

Outsunny C00-034V91
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Issues
Cause & Suggestions
Refrigerator does not work.
Check if the switch is on.
Check if the plug and socket are securely connected.
Check to see if the fuse is burnt.
Check if there is damage to the cord.
Frequently switching on/off could cause a delay to the
compressor.
Refrigerator compartments
are too warm.
The door is opened frequently.
A large amount of warm or hot food was recently stored.
The refrigerator has been disconnected for a long time.
Food is frozen.
The temperature is set too low
There is ‘water flowing’
noise from inside the
refrigerator.
This is normal.
There are waterdrops
around the refrigerator
casing or door gap.
This is normal. The moisture will condense to water when it
touches the cold surface.
The compressor is slightly
noisy when starting.
This is normal. The noise will reduce once the compressor
is fully running.
Code F1 displayed.
Possible cause: Low voltage.
Change the battery from high to medium or medium to
low.
Code F2 displayed.
Possible cause: Condenser fan is overloaded.
Disconnect the power to the fridge for five minutes and
restart.
If the code shows again, contact the manufacturer for
service.
Code F3 displayed.
Possible cause: The compressor starts too frequently.
Disconnect the power for five minutes and restart.
If the code shows again, contact the manufacturer for
service.
Code F4 displayed.
Possible cause: Compressor not starting
Disconnect the power for five minutes and restart.
If the code shows again, contact the manufacturer for
service.
Code F5 displayed.
Possible cause: Overheating of the compressor and
electronics.
Disconnect the power for five minutes and restart.
If the code shows again, contact the manufacturer for
service.
Code F6 displayed.
Possible cause: No parameter can be detected by the
controller.
Disconnect the power for five minutes and restart.
If the code shows again, contact the manufacturer for
service.
Code F7 or F8 displayed.
Possible cause: Temperature sensor is faulty.
Contact manufacturer for service.
7

Other manuals for Outsunny C00-034V91

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Outsunny C00-034V91 and is the answer not in the manual?

Outsunny C00-034V91 Specifications

General IconGeneral
BrandOutsunny
ModelC00-034V91
CategoryRefrigerator
LanguageEnglish

Related product manuals