1
Insert both ends of the
handlerbars (Part 1), into the
slide holes as shown below
(Part 2).
Insert the longer ended
handlebars into the two
holes closest to the top of
the slide.
Wiggle the shorter ends of
the handlebars into the two
remaining holes.
This step requires some
force.
Follow the steps shown in the pictures.
The product should initially only be screwed
finger-tight to ensure that it does not warp
and to facilitate the assembly. Only when all
parts are assembled, should they be firmly
tightened and checked.
Please take note of sharp-edged holes and
chips that under circumstances may occur
by the manufacture of this game device and
if necessary have these removed. These
products should be assembled by adults.
1. Do not install home playground equipment
over concrete, asphalt, packed earth, grass,
carpet, or any other hard surface. A fall on to
a hard surface can result in serious injury to
the user.
2. Do not place your product underneath
electrical lines. If you must ensure that there
is a minimum overhead clearance of 6’ 5” ft.
Assembly
11
2
To Next Page
Loading...