2 3
IMPORTANT INFORMATION:
• Do not let inatable products come in contact with sharp, pointed objects.
• Fill with cold air only. Never use a hair dryer to inate, this could cause melting.
• Do not over inate. Bursting items can cause serious injury. Inate the airbed
until most of the wrinkles in the material are gone and the bed feels rm to
touch.
CAUTION:
Air temperature and weather do aect the air pressure in inatable products. In
cold weather your airbed will lose some pressure due to the fact that the air will
contract. If this occurs, you may want to add a little air to improve your airbed’s
performance. However, in hot weather, the air will expand. You must let some
air out to prevent the airbed from failing due to overpressure. You should avoid
exposing your airbed to extreme temperatures (hot or cold).
INFLATING INSTRUCTION
WARNING:
Read airbed instruction manual and follow the safety instructions to avoid serious
injury or death.
Not for use by young children or people with limited disabilities. They may suo-
cate in a face down position or become trapped and suocate in the gap between
the airbed and adjacent furniture or wall. If the airbed is under inated or deates
during use, this risk of suocation may increase.
Do not let young children sleep on this airbed until they are mature enough to
sleep in an adult bed. Young children can suocate on adult beds (Including air-
beds), particularly when sleeping next to another person. Ask your paediatrician
for specic recommendations for your child.
Adult supervision required for ination and deation.
This airbed can melt or burn. Keep away from open ames, heaters, and other hot
objects. Do not smoke on or near the airbed.
This airbed is not for use in water. It is not a life saving device, personal otation
device, or water toy.
This airbed is not a toy. Do not stand, walk, jump or play on the airbed. This can
result in serious injury or damage to the airbed.
TO OPEN/CLOSE VALVE
INFLATION INSTRUCTION
To inate using the Outwell® Pump.
DEFLATION INSTRUCTION
To Open: Pull out the base valve from the bed
1
, open the cover
2
and take out the stopper
to release air
3
.
To Close: Reverse steps
1
,
2
&
3
to close the valve and push the base valve into the bed.
Pull out the base valve from the bed
1
, open the cover
2
and take out the stopper to release air
3
.
Do not puncture your airbed. Do not force air out of the airbed. Allow air to escape slowly and
naturally. Fold carefully and re-insert into the carrier bag.
To begin ination open external cap and pull
rmly on lanyard to extend out. This will open
internal seal.
When fully inated seal valve by pushing in
the pump nozzle. This will seal the internal
stopper and keep air from escaping while
closing cap.
Attach nozzle to ination end of pump. Insert
nozzle and turn on.
Fully remove pump and close external stop-
per. Valve should appear depressed into itself.
2
2
3
3
1
3
2
4
1
1
To Next Page
Loading...