Connecting the Controller
• Turn off power and remove the plug from power source
• To fit the controller plug, simply hold the socket with one hand and push the
controller plug all the way until it is firmly in place.
• To remove the controller, lift the locking tab up with your finger and pull the plug
directly out. Do not pull the controller cable and do not try and pull the controller
plug out without lifting the locking tab as you will damage the socket.
• Do not fold, roll or kink the cable. Allow the cable to hang freely.
• Ensure the cable is not pulled tight, so that it bends hard at the electric throw
blanket connector end.
Ensure the electric throw blanket is the appropriate size for the bed. The top must not hang
over the edges of the mattress.
SETTING UP
To Next Page
Loading...