EN
HOW TO USE
Connection
1. Put the shredder body on the bin.
2. Supply power to the shredder.
3. Set the switch into AUTO mode.
Description of modes
1. Automatic mode (AUTO). When AUTO mode is active, LED POWER
indicator will turn green. Paper will be shredded automatically when
you insert the paper into the slot. The shredder will stop automatically
when the paper goes through the slot completely.
2. Reverse mode (REV). After you have activated the reverse mode, the
motor will rotate in another direction, which allows removing the
jammed paper.
3. CD shredding mode/continual operation mode (CD/FWD). Enable this
mode if you want to destroy CDs through CD slot. In this mode the
motor in both slots rotates continuously.
4. Switching o (OFF). When OFF position is set, the shredder is inactive.
5. When the shredder is overheated, red indicator will go on. If this is the
case, stop shredding documents until the light vanishes.
Use restrictions
1. The slot accommodates max. 10 sheets of paper (220 mm wide, A4).
2. When shredding minor elements, such as envelopes or credit cards,
place them in the center of the slot.
3. Before you start shredding, remove staples and paper clips.
Jamming and overheating
The shredder is equipped with overheating protection. When the device is
overheated, the OVER HEATED indicator will go red.
To Next Page
Loading...