Before Using BabySat
5.1 Before First Use
Do the following before using BabySat
Read this entire User Manual
Understand the warnings and precautions
Set up the Owlet Care+ App (Section 7.2)
Fully charge the Sensor (Section 8.6).
for the first time
5.2 Operational Environment
BabySat is designed for use in the home.
CAUTION.
BabySat is NOT designed for use in moving vehicles.
CAUTION.
Keep BabySat away from electrical equipment that emits radio
frequencies to minimize radio interference. Radio interference may
aect performance.
CAUTION.
Keep Sensor out of direct sunlight when in use to minimize
interference that may aect performance.
5.3 Network Requirements
A Wi-Fi network is required to use BabySat to allow the Base Station to
communicate with the App and cloud servers. Information such as
Pulse Rate, Oxygen Saturation, alarms, and battery status are shared
over the network. The App will not function properly if the Base Station
is not able to connect to a reliable Wi-Fi network
A 2.4GHz IEEE 802.11 (b/g/n) Wi-Fi network using WPA2, or a similar
encryption method is required. Most home routers that operate at 5
GHz will also operate at 2.4 GHz. When connecting your devices, pick
the 2.4GHz connection.
CAUTION.
Make sure your router firewall is enabled and your router is
password protected. Also password-protect your mobile device and
keep the operating system updated.
The Base Station can remember up to 8 Wi-Fi networks making it easy
to move the device between locations (i.e., home, grandparents,
babysitter).
To add a new Wi-Fi network to an already set up device, refer to the
setup instructions in the App.
Account
>
My Owlet Devices (Select Device)
>
Change Wi-Fi
!
NOTE.
BabySat cannot be used with networks that require authentication via a
browser. These include many public networks like those found in hotels and
airports.
9
To Next Page
Loading...