8.3 Monitoring with BabySat
Aer setup is complete, use the following steps to turn on the Base Station
and begin monitoring the baby’s readings.
Disconnect the Sensor from the Base Station.
! NOTE.
The Sensor turns on automatically when disconnected from the
Base Station.
Insert the Sensor into the Sock, if needed.
Verify the Sensor is ON (check the red Sensor
light).
Apply the Sock with Sensor to your baby’s foot
ensuring proper fit and placement (see Section
8.1, Sock Fit & Placement).
Verify the Base Station is ON. The Base Station
will automatically turn on when the Sensor is
disconnected from the Base Station. If the Base
Station is OFF, press the Base Station to turn it on.
! NOTE.
The Base Station sounds a rising chime when the Base Station turns
on and the Base Station light ring will turn green.
Open the Owlet Care+ App on your mobile device.
Verify baby’s readings are normal.
CAU
T
I
ON.
Always verify BabySat is monitoring as e
x
pected aer turning
on the Base Station, repositioning the Sock or aer clearing
alarms.
8.
4
T
u
rning o
th
e
Ba
se
Station
M
onitoring with the Base Station should be turned o
when your baby is
active enough to cause repeated motion alerts or while washing your baby.
M
onitoring can be automatically turned o
by placing the Sensor on the
Base Station to charge. To turn o
the Base Station manually and end
monitoring
:
P
a
use
any a
c
ti
ve
a
l
ar
ms
.
WAR
N
I
N
G
!
If an alarm is active, check on the baby and resolve the alarm
condition.
L
ong press the Base Station for
3
seconds until you hear a chirp
and then let go O
R
toggle the Base Station toggle on the App.
! NOTE.
The Base Station light will turn o
and there will be a falling chime
sound indicating monitoring has ceased.
R
emove Sock and Sensor from baby’s foot
Visually inspect the Sock and Sensor for soiling & clean if
necessary (see Section 1
0
)
Place the Sensor on the Base Station to charge.
3
0
To Next Page
Loading...